opencast overburden extraction

opencast overburden extraction

Opencast Mining (Quarrying): Methods, Advantages ...

Opencast mining is also known as open-put mining, open-cut mining, surface mining and also as strip mining, the later term being commonly used in the U.S.A. for opencast mining of coal. The overburden and the mineral, coal, are excavated in long strips of a few metres thickness and hence the operations are termed strip mining.

Read More
opencast mining % - mineinformation opencast mining

Aug 30, 2020  Gradients of roads in quarries for types vehicular traffic should not exceed 1 to 10. Manual Opencast Working in Coat The quarriable area is divided into along the strike so that overburden extraction takes place in some sections and coal extraction in others which have the coal already exposed after overburden removal.

Read More
WASTE AND OVER BURDEN MANAGEMENT IN MEGA

☼ Over Burden/Waste generated during extraction of coal are being dumped both In-Pit as well as On External Dump. In-Pit Dumping is the most economical and environment friendly Waste Dump Management being adopted in Mega Opencast Projects. But it has certain limitations and inherent dangers of Dump Slides posing operational and Safety threats.

Read More
Surface Mining Techniques used in the Oil Sands Oil ...

May 01, 2016  Surface mining is defined as the extraction of ore from an open pit or burrow. Surface mining is sometimes known as open-pit, open-cut or open-cast mining and is only commercially viable if the deposit is located relative close to the surface. Less than 20% of Alberta's bitumen reserves

Read More
OVERBURDEN DUMP SLOPE STABILITY: A CASE STUDY AT

for the extraction and transportation of wastes in the opencast mine whose management is of prime importance. The problems relating to overburden dump slope stability is catching attention for safe working in adverse natural constraints. This paper examines the influence of various parameters such as slope height, slope

Read More
Planning Advice Note 50: controlling the environmental ...

Oct 31, 1996  Large volumes of temporary waste from overburden are produced by opencast coal extraction. Whilst top and subsoil mounds can have some of the effects of wastes, they are irreplaceable materials for restoration and should be carefully conserved and not regarded as waste.

Read More
Open Cut Coal Mine Animation - YouTube

Jun 06, 2013  This video showcases RPMGlobal's animation capabilities. For a full overview of implementing this software as part of your coal mining operation, please foll...

Read More
WASTE AND OVER BURDEN MANAGEMENT IN MEGA

☼ Over Burden/Waste generated during extraction of coal are being dumped both In-Pit as well as On External Dump. In-Pit Dumping is the most economical and environment friendly Waste Dump Management being adopted in Mega Opencast Projects. But it has certain limitations and inherent dangers of Dump Slides posing operational and Safety threats.

Read More
Combined Tipping and Opencast Coal Scheme at Bentinck ...

Jan 01, 1987  The site was fully exploited for coal extraction amounting to 268,000 tonnes and in such a manner as to minimise the cost of recovery. Advantage was taken of using the tipping site for overburden placing thus avoiding double handling. ... The area between the opencast overburden and lagoon L.14 was left low in order to accommodate Deep Mines ...

Read More
Niemtsch opencast mine - zxc.wiki

This began on March 10, 1949 the overburden extraction. Coal was mined in one main and two secondary fields ( Elsterfeld and Südfeld). In 1957 slides occurred near the Niemtsch mill, which buried the tracks. From May 26 to 27, 1959, a major fire in the opencast

Read More
Welzow-Süd opencast mine - LEAG.de

Overburden removal and dumping Once the soil layers have been sufficiently drained, overburden excavators start their operation and remo-ve sand, gravel, and clay covering the lignite seam. In the Welzow-Süd opencast mine, one bucket-wheel ex-cavator and one bucket-chain excavator are operated in the pre-cut of the overburden conveyor bridge and

Read More
Surface Mining Techniques used in the Oil Sands Oil ...

May 01, 2016  Surface mining is defined as the extraction of ore from an open pit or burrow. Surface mining is sometimes known as open-pit, open-cut or open-cast mining and is only commercially viable if the deposit is located relative close to the surface. Less than 20% of Alberta's bitumen reserves

Read More
Assessment of Dust Generation Due to Opencast Coal Mining ...

The main sources of air pollution have beenidentified. The rate of emission per unit of a given activityknown as an emission factor has been utilised, taking localfactors into account. It has been estimated that due to topsoilremoval, overburden (O/B) removal, extraction of coal, sizereduction generated 7.8 t of dust per day.

Read More
Extraction of developed pillars by opencast mine: acase study

Aug 11, 2015  Extraction of coal by Underground mining is very uneconomical. In future there will not be any virgin coal seam for opencast mining and only alternative for coal production will be by open casting of developed pillars of underground mines. There are nearly 3 to 3.5 BT of coal reserves in standing pillars in the country.

Read More
v117n3a2 Factors and challenges affecting coal recovery by ...

very thin. The extraction of the pillars was found to be feasible through the use of opencast mining methods due to the low stripping ratio, high recovery and extraction rate, and environmental and safety factors. This seam split was a function of the different products, with the pillar coal destined to produce export-type coal products and the ...

Read More
1.1 Mining-Opencast.pptx - PROC 8191 Mining and ...

r r d g Mine • Surface Mining: ove ore) is removed an • 1. open pit minin al Extraction burden (soil and rock on top of becomes spoil. – digging holes ping up underwater mineral n a flat area an earthmover – scraping ore from hilly • 2. Dredging – scra deposits • 3. Area Strip Mining – o strips overburden

Read More
BID DOCUMENT FOR HIRING OF EQUIPMENTS FOR

overburden. 62 4b (ii) stc for excavation, removal of overburden, extraction of coal and transportation. 67 4c special notes and additional terms conditionsfor hiring contract : excavation, removal of overburden, extraction of coal and transportation 75 4d vocational training and safety requirements. 83 5

Read More
THE FUNDAMENTALS OF OPEN CAST MINING - Mining Consultant India

Depending on the working site, opencast mining of mineral deposits includes stripping (removal, haulage and removal of overburden), mining proper (extractions, haulage and storage or unloading of the mineral) and development work that consists in making permanent trenches and other workings, for instance, underground.

Read More
PRE-FEASIBILITY REPORT OF SRIRAMPUR OPENCAST- II

which is carved out of Srirampur OCP Geological Block by opencast method up to a maximum depth of 350 m of No III seam. • It is proposed to extract the Coal and Ove-Dumper rburden with Shovel combination. The Overburden is proposed to be removed by outsourcing throughout the life of the Project whereas coal extraction is by departmental HEMM.

Read More
Mining and its impacts on environment with special ...

Opencast mining operations to result the minerals like limestone, bauxite, iron-, ores and coal are getting more emphasis because of obvious reasons but are associated with various environmental concerns. One of the major environmental challenges is to overburden generated in the opencast mines.

Read More
(PDF) IDENTIFICATION OF FAILURE SURFACES IN DRAGLINE DUMPS ...

Draglines are versatile excavating machines deployed to remove overburden in large opencast mines. In India, dragline mining is done to excavate overburden material in strips of 25m to 70m width depending upon the boom length i.e. reach of the machine. Limitation of dumping area within the pit leads to the formation of steep and high dragline ...

Read More
Opencast Mining - an overview ScienceDirect Topics

Mining and opencast mining in particular affect all components of ecosystems (Bradshaw, 1997).During opencast mining, material overlying the mined minerals, called overburden, is excavated and deposited in a heap. This heap can be located either inside the mine

Read More
FAM Opencast Mining Technology – Machines for Global Mining

In the area of opencast mining technology, FAM Förderanlagen Magdeburg offers an impressive selection of various machines and systems, such as bucket wheel excavators for extraction of mineral deposits like lignite, hard coal, overburden, marl. These raw materials can be then used for further processing, for example, in production of metals or ...

Read More
F60 Operating Principle

The overburden conveyor bridge is a steel construction with implemented belt-systems. It spans the whole opencast mining area and connects the extraction-side (extraction of overburden) with the side where the overburden was dropped. The F60 served to skim the brown cole, i.e. to seperate it from the overburden (the layers of earth that lie ...

Read More
OPENCAST PLATINUM MINE PROJECT Miningreview

Sep 29, 2008  Hand-in-glove with skilled and qualified personnel are the production focused items of plant. “We have five bulk excavators for overburden removal; six smaller excavators for cleaning the ore body and extraction of the ore body; five dozers for moving overburden and top soil; 25 trucks on site; three water carts and various ancillary support plant.

Read More
Assessment of Dust Generation Due to Opencast Coal Mining ...

The main sources of air pollution have beenidentified. The rate of emission per unit of a given activityknown as an emission factor has been utilised, taking localfactors into account. It has been estimated that due to topsoilremoval, overburden (O/B) removal, extraction of coal, sizereduction generated 7.8 t of dust per day.

Read More
(PDF) A review on existing opencast coal mining methods ...

Opencast coal mining on a large scale first commenced in Australia in the 1960's.Today, draglines and truck and shovel operations, or a mixture of the two, are the predominant types of equipment used in open cut mines, as seen in Fig. 2. ... .One mine currently still utilizing dredgers for both overburden removal and coal extraction is Dredgers ...

Read More
Extraction of developed pillars by opencast mine: acase study

Aug 11, 2015  Extraction of coal by Underground mining is very uneconomical. In future there will not be any virgin coal seam for opencast mining and only alternative for coal production will be by open casting of developed pillars of underground mines. There are nearly 3 to 3.5 BT of coal reserves in standing pillars in the country.

Read More
1.1 Mining-Opencast.pptx - PROC 8191 Mining and ...

r r d g Mine • Surface Mining: ove ore) is removed an • 1. open pit minin al Extraction burden (soil and rock on top of becomes spoil. – digging holes ping up underwater mineral n a flat area an earthmover – scraping ore from hilly • 2. Dredging – scra deposits • 3. Area Strip Mining – o strips overburden

Read More
Surface Mining Techniques used in the Oil Sands Oil ...

May 01, 2016  Surface mining is defined as the extraction of ore from an open pit or burrow. Surface mining is sometimes known as open-pit, open-cut or open-cast mining and is only commercially viable if the deposit is located relative close to the surface. Less than 20% of Alberta's bitumen reserves

Read More
v117n3a2 Factors and challenges affecting coal recovery by ...

very thin. The extraction of the pillars was found to be feasible through the use of opencast mining methods due to the low stripping ratio, high recovery and extraction rate, and environmental and safety factors. This seam split was a function of the different products, with the pillar coal destined to produce export-type coal products and the ...

Read More
Analysis of Highwall Mining Stability - The Effect of ...

overburden depth can be used to calculate web pillar stress. This is the overburden under which 80% of the HWM panel exists or alternatively may be calculated using equation 2 where a continuous slope is present. OBDesign = 0.75 * OBMAX + 0.25 * OBMIN (2) Where: OBMAX = maximum overburden depth OBMIN = minimum overburden depth.

Read More
(PDF) IDENTIFICATION OF FAILURE SURFACES IN DRAGLINE DUMPS ...

Draglines are versatile excavating machines deployed to remove overburden in large opencast mines. In India, dragline mining is done to excavate overburden material in strips of 25m to 70m width depending upon the boom length i.e. reach of the machine. Limitation of dumping area within the pit leads to the formation of steep and high dragline ...

Read More
Planning Advice Note 50: controlling the environmental ...

Oct 31, 1996  Large volumes of temporary waste from overburden are produced by opencast coal extraction. Whilst top and subsoil mounds can have some of the effects of wastes, they are irreplaceable materials for restoration and should be carefully conserved and not regarded as waste.

Read More
Open-pit mining – General Overview - Protect Ecuador ...

Open-pit mining (also known as open-cut mining or opencast mining) ... necessitating the removal of layer upon layer of overburden and ore. ... If a mining project involves the extraction of a few hundred million metric tons of mineral ore, then the mine project will generate a similar quantity of tailings. ...

Read More